The RaceLyx phone app can time a rally on its own, with RaceLyx gates and the RaceLyx Communicator, the box that talks to the gates by radio. The phone connects to the Communicator by Bluetooth and the beams time each run. Results are saved on the phone.
Before you start
- The RaceLyx app on your phone, with Bluetooth on.
- A RaceLyx Communicator with firmware 2.6.0 or newer, and the gates switched on.
Step by step
- 1
Open Rally
On the Race tab, under Other formats, tap Rally.
The Race tab is in the bar at the bottom. Rally opens with the timing source set to Rally Gates.
- 2
Connect the Communicator
Switch on the RaceLyx Communicator and tap Scan for Gate Master. Tap it in the list.
The Communicator is the box that talks to the gates by radio. It shows in the list as RaceLyx-Master and needs firmware 2.6.0 or newer for Bluetooth. Allow Bluetooth when the phone asks.
- 3
Set up the course
Tap Set up the course.
The Rally screen has FORMAT, TIMING, START LINE, CLASSES, ENTRANTS and COURSE cards, with Gate check at the top right.
- 4
Format and timing
Under FORMAT, choose Runs or Stage Rally, and the runs each. Under TIMING, choose Two gates.
Runs: everyone gets the same number of runs, scored on Best Run or Average. Stage Rally: everyone runs each stage once and the times add up. Two gates uses a start and a finish beam; One loop uses one gate for both.
- 5
Add the entrants
Under ENTRANTS, type each driver's name and add them, in running order.
Drivers from your roster can be picked as you type. The app calls each car up in turn and the beams do the timing. Running clock, under START LINE, calls the next car up on a fixed interval instead.
- 6
Gate check
Tap Gate check at the top to see every gate. Break each beam once to check it.
Rally Gates lists each gate as it heartbeats, every 5 seconds, and each crossing as it happens. Nothing here is scored. Reset gates clears them; go back when every gate has answered.
- 7
Start and run
Tap Start session, then Stage next driver. The start beam starts the clock and the finish beam stops it.
ON STAGE shows who is up: Staged, waiting for the start beam. If a beam misses, tap Finish run to stop the clock by hand. The More menu has DNF this run and DNS this run.
- 8
End session and save
When every run is in, tap End session and save.
The standings are saved to History on the phone, and to your track's page too when publishing is on. Share results, in the More menu, sends them on.
Tips
- The app still calls the Communicator the gate master, and it shows in the Bluetooth list as RaceLyx-Master.
- Beams cannot tell cars apart: the app calls each car up in turn, one on course at a time.
- Under TIMING, One loop uses one gate for both the start and the finish.
- Under COURSE, add three or more gates to time a whole course, each gap a stage.
- Red flag, at the top of the race screen, ignores crossings until you resume.
Troubleshooting
- The Communicator is not in the list.
- Switch it on next to the phone and scan again. It needs firmware 2.6.0 or newer for Bluetooth.
- "Crossing ignored: nobody is staged."
- Tap Stage next driver before the car breaks the start beam.
- "Finish ignored: too quick to be a real run."
- A beam fired too soon after the start. If the run really finished, tap Finish run to stop it by hand.
- "Gate master disconnected"
- The phone lost the Communicator. Bring the phone closer; the runs already recorded are kept.
Related guides
Something here does not match what you see? Tell us and we will fix the guide.