Chapter 6: Results and reports

Recover a lost heat

Rebuild a heat result from the stored passings when it was lost or reset by mistake: pick when it ran, who was in it, and how it was run.

For race directors about 1 min 5 steps

RaceLyx keeps every passing the decoder sends. If a heat was reset by mistake, or the PC crashed before saving, Recover a heat scores it again from those passings.

Before you start

  • The heat was run with a decoder connected, on this PC.

Step by step

  1. 1

    Recover a heat

    On Results, History, click Recover a heat.

    Open Results, Recent Results, History. Recover a heat sits at the top of the Live and History tabs, and scores a heat again from the stored passings.

  2. 2

    When it ran

    Pick when it ran from the list. Then check the green flag and the last passing.

    The list shows bursts of timing from the last 12 hours, newest first, with the cars and passings in each, and Saved as a session or No saved result. Picking one fills Green flag and Last passing to count. Move Green flag to the real start.

  3. 3

    Who was in it

    Untick every car that was not in this heat. Every transponder seen in that time starts ticked.

    The heading counts them, like "Who was in it (4 of 16 ticked)". Cars warming up for the next heat crossed too, so untick them. Under Decoders to count, untick a pit lane or sector loop.

  4. 4

    How it was run

    Name it, then set the format, the minutes and the minimum lap.

    Format is Timed race, Lap race, Qualifying or Practice. Set Minutes or Laps as it was run. Min lap (s) is your class minimum lap: it throws out double reads. Keep Cars finish the lap they are on when time is up ticked for a normal finish, and tick File it under the event so it counts in the event's results.

  5. 5

    Rebuild and save

    Click Rebuild to check it, then Save result.

    The preview lists Pos, Driver, Laps, Time and Best. Change anything and click Rebuild again. Save result puts it in History. If the list said Saved as, the heat was saved before: delete the old copy so it does not count twice.

Tips

  • Recover the same night if you can: the list only reaches back 12 hours. Older heats need the times typed in.
  • Set the green flag time and the last passing to count, so warm-up laps do not sneak in.
  • Recover names drivers by the transponders on your Drivers list now. Fix a wrong transponder first and the rebuilt result names the right driver.
  • Rebuild shows the result before you save it. Rebuild again after changing anything.
  • A recovered heat is not given Event Standings points by itself; only heats saved from Race Control are.

Troubleshooting

The rebuilt laps look too high.
The time window starts too early. Move Green flag later.
"No passings in the last 12 hours. Set the start and end below."
The heat ran earlier. Type when it started under Green flag, and when the last car crossed under Last passing to count.
"Nobody in the lineup crossed the line in that window."
The times are wrong, or every car is unticked. Widen the window or tick the cars.

Related guides

Something here does not match what you see? Tell us and we will fix the guide.

Up next Merge and compare results about 1 min