Chapter 15: Race control

Restart a heat in progress

Abandon a heat that is under way, for a jumped start, a pile-up or a timing fault: Stop Session, Reset, then stage and start it again.

For race directors about 1 min 5 steps

Sometimes a heat has to start again from the beginning: a jumped start, a first-lap pile-up, or a decoder that missed the start. RaceLyx has no Abort button. You stop the session, throw its laps away with Reset, and stage the same heat again.

Before you start

  • A heat running.

Step by step

  1. 1

    A heat on track

    A heat is under way. Something goes wrong in the first lap, and it has to start again.

    Here a qualifying heat has just started. A jumped start, a first-corner pile-up or a decoder that missed the start are the usual reasons to start again from scratch.

  2. 2

    Stop Session

    Click Stop Session. The clock stops and the heat shows Finished.

    Stop Session in the control bar ends the heat now, without waiting for cars to finish their lap. Pressing Space does the same, with no question. Nothing is saved yet: Save & Next Heat and Reset appear.

  3. 3

    Reset

    Click Reset. RaceLyx asks first, because the laps are thrown away.

    The question reads "Reset without saving?": its laps and finishing order are cleared and cannot be recovered from this screen. The stored passings stay on the PC, so Recover a heat can still rebuild it.

  4. 4

    Reset race

    Click Reset race. The same heat is back in the preview, ready to stage.

    Nothing went to Results and no points were filed. The heat strip still shows this heat as the next one to run, not as Already run.

  5. 5

    Stage it again

    Click Stage Heat, let roll call tick the cars off, and start as normal.

    Roll call starts over. Give the drivers a moment to line up again, then click Start Race. The new run is the one you save.

Tips

  • Space during a heat stops it at once, with no question. Use it when the cars must stop now, then decide whether to save or reset.
  • Reset asks first. Its laps and finishing order cannot be brought back from that screen.
  • Escape on a finished heat resets it too, after asking.
  • The passings stay stored on this PC. Reset a heat that should have counted? Recover a heat in Results can rebuild it.
  • Which one? Restart: the heat is still on the clock and should not count. Re-run: it was saved, but the race has to happen again. Recover: the race happened but the result was lost.

Troubleshooting

I stopped the heat by mistake.
A stopped heat cannot be resumed. If the result is fair, save it as it stands with Save & Next Heat. If not, Reset and run it again.
Stage Heat is not there.
The last heat is finished and not saved: the live panel shows Save & Next Heat and Reset. Pick one first.
Only one or two cars jumped the start.
No need to restart. Jump start detected names each car that crossed before green and offers +5s, +10s or DSQ.

Related guides

Something here does not match what you see? Tell us and we will fix the guide.

Up next Missed reads and timing warnings about 1 min