Streaming Setup is a page the display server serves for whoever runs the stream: every overlay and screen address, a Look choice, and the OBS steps. Open it on the streaming PC and copy from there, without touching race control.
Before you start
- The display server running on the timing PC.
- OBS, or other streaming software, on this PC or another PC on the same network.
Step by step
- 1
Start the display server
On Displays, click Start server.
The address shown is this PC's network address, for example http://192.168.1.20:8080. Any PC on the network can open the pages it serves.
- 2
Copy the Streaming Setup address
On the Screens tab, find Streaming Setup and copy its address.
Streaming Setup: overlay URLs and OBS instructions in one page. Its address ends in /stream. The open button opens it in this PC's browser.
- 3
Open it on the streaming PC
On the streaming PC, paste the address into a browser. Pick the Look: Dark for OBS.
The page has Look (Theme Dark or Light, and Screen size), OBS overlays, Screens, OBS Setup Instructions and Streaming Platform Tips. Every address on it follows the Look you pick.
- 4
Copy an overlay URL
Under OBS overlays, press Copy URL on the one you want.
Each card says what the overlay is and where it sits on the picture, for example Position Tower, Left edge. Screens lists the full-page screens for TVs, tablets and phones.
- 5
Add a Browser source
In OBS, under Sources press plus, choose Browser, paste the URL, and set 1920 by 1080.
Width 1920, Height 1080. Tick Shutdown source when not visible, to save resources, and Refresh browser when scene becomes active. The overlay is see-through, so no chroma key is needed.
Tips
- Dark suits OBS, where overlays sit on race video. Light suits a projector or a TV in daylight.
- Screen size (1.25x, 1.5x, 2x) applies to the screens, not the overlays.
- Each overlay says where it sits, for example Position Tower on the left edge, Lower Third along the bottom, Minimal in the top right corner.
- The page does not add the stream delay. For overlays that run ahead of the camera, add ?delay=3 to the address, or copy it from Displays, OBS overlays, after setting Stream delay.
- In OBS, tick Refresh browser when scene becomes active, so an overlay that came up blank loads again.
Troubleshooting
- Streaming Setup will not load on the streaming PC.
- Check both PCs are on the same network, and allow RaceLyx through Windows Firewall on the timing PC.
- "Could not load the overlay list. Reload the page."
- The page could not reach the display server. Check it is running, then reload.
- The overlays went blank after RaceLyx moved to 8081.
- Another program took 8080. Open Streaming Setup at the new address and paste the new URLs into OBS.
Related guides
Something here does not match what you see? Tell us and we will fix the guide.